ES910 Compact Rapid Prototyping Module
The ES910 is a Rapid Prototyping Module for the function development via ETK/XETK Bypass and direct bus access. The ES910 has a simulation controller and the ECU interfaces CAN, LIN, ETK, and XETK as well as an interface to an ES400 and ES63x Daisy Chain.
Note |
ES400 and ES63x devices in Daisy Chain arrangement that are connected to an ES910 module are displayed under the Daisy Chain Modules system in the tree view of the Hardware Configuration Editor. |
System limits
- Two CAN interfaces
- Two LIN interfaces
- One ETK interface
- One IO Daisy Chain (for ES400 and ES63x modules, under the Ethernet system)
- One XETK interface (under the Ethernet system)
- One Simulation Controller
INCA supports only one ES910 module at a time.
Note |
The configuration of the LIN interface is possible only if the INCA-LIN add-on was also installed. |
Note |
|---|
The Simulation Controller (Rapid Prototyping interface of the ES910) is only available if the INCA-EIP add-on was also installed. |
Note |
|---|
The ES910 device can be expanded with either an ES920 FlexRay Module or an ES921 CAN Module, thus offering additional interfaces. The ES920 and ES921 are displayed in the Hardware Configuration Editor as separate devices under the ES910 system. |
Module parameters
Parameters tabNameEnter any name for the system.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Alias nameEnter an internal name of the device. It is stored in the device like the serial number and helps you to distinguish between devices of the same type. By assigning a unique name which expresses the role of the device, it can be used more conveniently than the serial number, especially when you link the devices in the Hardware Mapping dialog box. The alias name is used, for example, if you switch between different vehicles when measuring with the laptop or if you have installed different devices of the same type in the vehicle.
Firmware versionShows the firmware version of the connected hardware module.
INCA hardware communicationShows the hardware connection between the hardware and the PC.
You cannot edit this field.
Application options
Via the CAN interface:
Measurement and Serial Calibration Using CCP
Measurement and Calibration Using UDS (Unified Diagnostic Services)
Model Based Application Using XCPSimTime
Diagnostics Using OBDonCAN (available only with ODX add-on)
Via the LIN interface:
Via the ETK interface:
Using the ES910 SimulationController:
Rapid Prototyping Using Simulation Controller (available only with INCA-EIP add-on)
Working in the Hardware Configuration Editor