ES921 CAN Module
The ES921 CAN Module adds two CAN bus interfaces to the ES910 / ES910.3 Rapid Prototyping Module. It is plugged into the extension slot of the ES910 / ES910.3 module.
System limits
- Two CAN interfaces
Module parameters
The ES921 itself has no properties for which parameters can be set. Therefore, if you click the corresponding entry under Hardware devices, the right side of the window remains blank.
Application options
Via the CAN interface:
Measurement and Serial Calibration Using CCP
Measurement and Calibration Using UDS (Unified Diagnostic Services)
Model Based Application Using XCPSimTime
Diagnostics Using OBDonCAN (available only with ODX add-on)
Working in the Hardware Configuration Editor