Vector VX1161.41
The VX1161.41 Network Interface Card is a hardware from Vector with interfaces for CAN and FlexRay. The Ethernet interface behaves like a switch.
Note |
The operation of the VX1161.41 Network Interface Card requires a computer driver which is provided with the hardware by the hardware manufacturer. To operate a VX1161.41 Network Interface Card, you need a valid ETAS license. |
System Limits
VX1161.41A Network Interface CardThe Vector VX1161.41A is available in various variants. POD connectors are not supported.
Interfaces:
- 6 CAN interfaces
INCA supports four VX1161.41A Network Interface Cards simultaneously.
VX1161.41B Network Interface CardThe Vector VX1161.41B is available in various variants. POD connectors are not supported.
Interfaces:
- 6 CAN interfaces
- 1 FlexRay interface
INCA supports four VX1161.41B Network Interface Cards simultaneously.
Module Parameters
Parameters tabNameEnter any name for the hardware module.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Firmware versionShows the firmware version of the connected hardware module.
INCA hardware communicationShows the hardware connection between the hardware and the PC.
You cannot edit this field.
Application options
Via the CAN interface:
Model Based Calibration Using XCPSimTime
Diagnostics Using OBD on CAN (available only with ODX add-on)
Via the FlexRay interface:
FlexRay Monitoring (available only with INCA-FlexRay add-on)
Calibration Using XCP (FlexRay Bus) (available only with INCA-FlexRay add-on)
Via the XCP on Ethernet interface
Measurement and Calibration Using XCP (Ethernet)
Working in the Hardware Configuration Editor