Measurement and Calibration Using XCP (FlexRay Bus)

XCP (eXtended Calibration Protocol) is a vendor- and interface-independent protocol for communication between calibration tools and control units. XCP was specified in the ASAM e.V.

The FlexRay bus is used for high-speed and deterministic data exchange with the ECUs.

Some parameters that are displayed in the Hardware Configuration Editor are loaded from the A2L file in advance.

Several acquisition rates can be acquired using XCP on FlexRay.

XCP allows you to use a FlexRay connection to access the ECU-supported memory options. All functions required for memory page management are available using this connection.

Open the Hardware Configuration Editor or experiment environment dialog box to run the Memory Page Manager.

Note
Specifications for implementing XCP in ETAS calibration systems can be obtained directly from ETAS.