Vector VX113x

The VX113x Base Modules are hardware from Vector with interfaces for CAN, CAN FD, FlexRay, and Ethernet. The Ethernet interface behaves like a switch.

The VX113x Base Modules support the application via the CAN interface of an ECU as well as captures and records communication data on the network for CAN, CAN FD, FlexRay, and Ethernet.

Note

The configuration of the FlexRay interface is possible only if the add-on INCA-FlexRay is also installed.

The operation of the VX1132 and the VX1135 requires a computer driver which is provided with the hardware by the hardware manufacturer.

To operate VX113x Base Modules, you need a valid ETAS license.

System Limits

The Vector Base Module VX1132 is available in various variants. POD connectors are not supported.

Interfaces:

  • 4 CAN interfaces

INCA supports two VX1132 Base Modules simultaneously.

The Vector Base Module VX1135 is available in various variants. POD connectors are not supported.

Interfaces:

  • 1 FlexRay interface
  • 5 CAN / CAN FD interfaces
  • 1 BroadR-Reach/Ethernet

    • INCA supports two VX1135 Base Modules simultaneously.

Module Parameters

Enter any name for the hardware module.

Shows the serial number read from the device.

If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).

The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.

Shows the firmware version of the connected hardware module.

Shows the hardware connection between the hardware and the PC.

You cannot edit this field.

Application options

Via the CAN interface:

CAN Monitoring

CAN Output

Serial Calibration Using CCP

Calibration Using UDS

Model Based Calibration Using XCPSimTime

Diagnostics Using OBD on CAN (available only with ODX add-on)

Via the FlexRay interface:

FlexRay Monitoring (available only with INCA-FlexRay add-on)

Calibration Using XCP (FlexRay Bus) (available only with INCA-FlexRay add-on)

Working in the Hardware Configuration Editor

Adding a Device

Changing Parameter Values