Vector VN76xx

The VN76xx interfaces are hardware from Vector with interfaces for FlexRay, CAN, CAN FD, and LIN. The modules need an USB or an Ethernet port.

The VN76xx family supports the application via the CAN, CAN FD, and FlexRay interface of an ECU as well as captures and records communication data on the network for CAN, CAN FD, LIN, and FlexRay.

Note

The configuration of the FlexRay and LIN interface is possible only if either the add-on INCA-FlexRay or the add-on INCA-LIN was also installed.

The operation of the VN7600, the VN7610, and the VN7640 requires a computer driver which is provided with the hardware by the hardware manufacturer.

To operate Vector interfaces with ETAS software, you need a license. Contact your local ETAS sales representative to get a subscription software license or an enabling key.

System Limits

The Vector FlexRay interface VN7600 is a CAN and FlexRay interface which can be used via USB port.

Interfaces:

  • 1 FlexRay interface
  • 3 CAN interfaces

INCA supports up to four VN7600 modules simultaneously.

The Vector FlexRay interface VN7610 is a CAN, CAN FD, and FlexRay interface which can be used via USB port.

Interfaces:

  • 1 FlexRay interface
  • 1 CAN / CAN FD interface

    • INCA supports up to four VN7610 modules simultaneously.

The Vector interface VN7640 is a FlexRay, CAN, CAN FD, LIN, and Ethernet interface which can be used via USB or Ethernet port.

Interfaces:

  • Up to 1 FlexRay interface
  • Up to 4 CAN / CAN FD interfaces
  • Up to 4 LIN interfaces
  • Ethernet port as host interface to computer

    INCA supports up to four VN7640 modules simultaneously.

Module parameters

Enter any name for the hardware module.

Shows the serial number read from the device.

If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).

The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.

Shows the firmware version of the connected hardware module.

Application options

Via the CAN interface:

CAN Monitoring

CAN Output

Serial Calibration Using CCP

Calibration Using UDS

Model Based Calibration Using XCPSimTime

Diagnostics Using OBD on CAN (available only with ODX add-on)

Via the FlexRay interface:

FlexRay Monitoring (available only with INCA-FlexRay add-on)

Calibration Using XCP (FlexRay Bus) (available only with INCA-FlexRay add-on)

Working in the Hardware Configuration Editor

Adding a Device

Changing Parameter Values