Hardware Status List

The Hardware Status List shows the status parameters. In detail these parameters are:

ECU Page

Shows which page is currently activated.

Reference Page: The Reference Page is activated.
Working Page: The Working Page is activated.

ECU page switching is not supported for all (X)ETK devices. For devices not supporting page switching, it is device configuration dependant which page is available.
Example: the XETK-V2 can be setup in a way that there is no page switch and only the Reference Page is available.

Page Initialization

Shows the status of the page initialization.

Initialized from backup flash: The working page and the reference page contain the calibration data from the backup flash.
Not initialized from backup flash: Working page and reference page contain random data.
Write access after initialization from backup flash: The calibration data have been modified by the measurement and calibration tool.
Unknown: No statement because information is faulty.

ECU Ignition

Shows the ECU ignition status.

On: Ignition is 'On'.
Off: Ignition is 'Off.
Unknown: No statement because information is faulty.

Calibration Data

Shows the Calibration Data status.

Initialized from backup flash: Only calibration data from (backup) flash are available.
Modified: Calibration data has been modified by the measurement and calibration tool.
Unknown: No statement because information is faulty.

ECU Reset

Shows states of a ECU Reset.

Not driven by XETK: The XETK device does not cause an ECU Reset. It is unknown if there is an ECU Reset.
Driven by XETK: The XETK device causes an ECU Reset.
Driven by external source: An external source causes an ECU Reset.
Unknown: No statement because information is faulty.

Microcontroller Type

Shows the type of the microcontroller the (X)ETK is connected to.

ECU Handshake

Shows the status of the handshake between the ECU and the (X)ETK. Possible states are:

Performed
Not Performed
Performed by Timeout
Unknown

This parameter is displayed only for serial (X)ETKs.

Trace Interface Status

Shows states of the trace interface. Possibles states are:

Not supported
Link in Reset
Signal on link received
Physical layer established (PLL locked)
Link up
Link communication error

During the initialization phase, the trace interface state will move through the states in order:

Link in Reset
Signal of Link received
Physical layer established
Link up

If a problem occurs during initialization, the last successful state will be displayed. If an error occurs after the initialization is complete “Link communication Error” will be displayed. The state “Not supported” indicates that the firmware version does not send the trace interface status, and can be resolved through a HSP update.

This parameter is displayed only for the FETK-T1.0