ES592 Interface Module (ETK, CAN, LIN and Ethernet)
The ES592 is a fully Ethernet-compatible compact device for high-performance applications. It supports all important functions for control device application via memory emulation with an ETK.
Additionally, it enables connection to the control device via the CAN interface. This way, it can be used for all functions designed to operate the diagnostic services of a control unit, such as reading the error memory or programming control units using flash memory. It also support recording and capturing communication data that is exchanged using CAN. The ES592 automatically handles data exchange and relieves the PC from all time-critical protocol tasks.
Moreover, the ES592 supports LIN monitoring.
ES400 and ES63x devices in Daisy Chain configuration that are connected to an ES592 module are displayed under the Daisy Chain Modules system in the tree view of the Hardware Configuration Editor.
XETK devices that are connected to an ES592 module are displayed under the Ethernet system in the tree view of the Hardware Configuration Editor.
System limits
The ES592 has the following interfaces:
- Two CAN interfaces
- Two LIN interfaces
- One ETK interface
The configuration of the LIN interface is possible only if the Add-On INCA-LIN was also installed.
INCA supports up to eight ES592 modules simultaneously.
Regardless of which interfaces you use, you have to set global parameters for the ES592. These settings then apply to all integrated interfaces.
Module parameters
Parameters tabNameEnter any name for the system.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Alias nameEnter an internal name of the device. It is stored in the device like the serial number and helps you to distinguish between devices of the same type. By assigning a unique name which expresses the role of the device, it can be used more conveniently than the serial number, especially when you link the devices in the Hardware Mapping dialog box. The alias name is used, for example, if you switch between different vehicles when measuring with the laptop or if you have installed different devices of the same type in the vehicle.
Firmware versionShows the firmware version of the connected hardware module.
INCA hardware communicationShows the hardware connection between the hardware and the PC.
You cannot edit this field.
Application options
Via the CAN interface:
Measurement and Serial Calibration Using CCP
Measurement and Calibration Using UDS (Unified Diagnostic Services)
Model Based Application Using XCPSimTime
Diagnostics Using OBDonCAN (available only with ODX add-on)
Via the LIN interface:
Via the ETK interface:
Via the Ethernet interface:
Module Parameter for Ethernet (ETH) Interface
Module Parameter for Ethernet Monitoring
Working in the Hardware Configuration Editor