Toolbar Elements – Block Diagram Editor

The Elements toolbar contains the following buttons:

Variable

The button opens the element type selection menu. The Variable and Parameter buttons can be used to create elements of type logic, limitInt, wrapInt, udisc, sdisc, or cont.

Note

By default, the limitInt and wrapInt types are displayed. To display the sdisc and udisc types instead, the editor optionUse signed/unsigned discrete types must be activated.

See also Creating a Basic Element.

Parameter

Implementation Cast

See also Implementation Casts in Block Diagrams.

Delta t

dt system parameter

Note

The name dT is reserved for the system parameter. You cannot create any other element with the name dT. Since upper-case and lower-case letters are not distinguished, the names DT, dt, and Dt are reserved, too.

Resource

See also Resources.

Receive Message

These buttons can be used to create scalar messages only.

See also Creating a Message.

Send Receive Message

Send Message

Array

See also Creating an Array or Matrix.

Matrix

Distribution

See also Creating a Distribution.

OneD Table

The button opens the table type selection menu. The table buttons can be used to create normal, group, or fixed tables.

See also Creating a Normal or Fixed Characteristic Line/Map and Creating a Group Characteristic Line/Map.

TwoD Table

See also

Elements Palette