Elements Palette

The Elements palette contains following functions:

Logic Variable

The Variable and Parameter buttons can be used to create elements of type logic, limitInt, wrapInt, udisc, sdisc, cont, or enumeration.

Note

By default, the Limited Integer * and Wrap-Around Integer * buttons are displayed. To display the Signed Discrete * and Unsigned Discrete * buttons instead, the editor optionUse signed/unsigned discrete types must be activated.

See also Creating a Basic Element and Inserting an Enumeration.

()

Limited Integer Variable
(Signed Discrete Variable)

()

Wrap-Around Integer Variable
(Unsigned Discrete Variable)

Continuous Variable

Enumeration Variable

Logic Parameter

()

Limited Integer Parameter
(Signed Discrete Parameter)

()

Wrap-Around Integer Parameter
(Unsigned Discrete Parameter)

Continuous Parameter

Enumeration Parameter

Implementation Cast

Delta t

dt system parameter

Note

The name dT is reserved for the system parameter. You cannot create any other element with the name dT. Since upper-case and lower-case letters are not distinguished, the names DT, dt, and Dt are reserved, too.

Resource

See also Resources.

Receive Message

These buttons can be used to create scalar messages only.

See also Creating a Message.

Send Receive Message

Send Message

Array

See also Creating an Array or Matrix.

Matrix

Distribution

See also Creating a Distribution.

OneD Table

The table buttons can be used to create normal, group, or fixed characteristic lines/maps, depending on the selection in the combo box.

See also Creating a Normal or Fixed Characteristic Line/Map and Creating a Group Characteristic Line/Map.

TwoD Table

Combo box to select the type of the characteristic line/map

See also

Toolbar Elements