Vector VN5xxx
The VN5000 Ethernet Interface family are Vector network interfaces that support Ethernet physical layer.
The operation of the VN5000 family modules require a computer driver that is provided with the hardware by the hardware manufacturer.
INCA supports the new driver mode Network-based Mode for the VN5000 family modules.
Note |
The operation of the VN5000 family modules with ETAS software must be enabled by ETAS. Contact your local sales representative to get a license. |
System Limits
INCA supports up to two modules of each VN5000 family device type simultaneously:
CAN | CAN FD | LIN | FLX | ETH | ||
|---|---|---|---|---|---|---|
VN5420 | Automotive Ethernet Interface | x | ||||
VN5430 | Automotive Ethernet Interface | x | ||||
VN5610(A) | Ethernet/CAN Interface | x | x | x | ||
VN5611 | Ethernet Interface | x | ||||
VN5612 | Ethernet Interface | x | ||||
VN5620 | Ethernet/CAN Interface | x | x | x | ||
VN5640 | Ethernet/CAN Interface | x | x | x | ||
VN5650 | Ethernet/CAN Interface | x | x | x |
Module Parameters
Parameters tabNameEnter any name for the hardware module.
Serial NumberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Firmware VersionShows the firmware version of the connected hardware module.
Application options
Via the CAN interface:
Model Based Calibration Using XCPSimTime
Diagnostics Using OBD on CAN (available only with ODX add-on)
Via the Ethernet (ETH) interface:
Working in the Hardware Configuration Editor