Vector VN1630

The Vector VN1630 supports the application via the CAN interface of an ECU as well as captures and records communication data on the network for CAN and LIN. Moreover, it provides integrated I/O interfaces. The VN1630 is connected to the computer via USB.

Note

The configuration of the LIN interface is possible only if the add-on INCA-LIN was also installed.

Depending upon usage (CAN or LIN), you require the appropriate connecting cable for the VN1630.

The operation of the VN1630 requires a computer driver which is provided with the hardware by the hardware manufacturer.

The operation of the VN1630 with ETAS software must be enabled by ETAS. Please contact your local sales representative to get the enabling key.

System limits

The VN1630 module provides 2 CAN interfaces. It can be expanded with 2 additional CAN or LIN interfaces.

INCA supports up to four VN1630 modules simultaneously.

Module parameters

Enter any name for the hardware module.

Shows the serial number read from the device.

If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).

The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.

Shows the firmware version of the connected hardware module.

Application options

Via the CAN interface:

CAN Monitoring

CAN Output

Serial Calibration Using CCP

Calibration Using UDS

Model Based Calibration Using XCPSimTime

Diagnostics Using OBD on CAN (available only with ODX add-on)

Via the LIN interface:

LIN Monitoring

Working in the Hardware Configuration Editor

Adding a Device

Changing Parameter Values