TS Test System
The TS test system simulates a real hardware. The test system can be used to measure simulated measured values and change calibration variables without using real hardware. However, the test system does not perform any raster check and is, therefore, not suitable for preparing a real experiment. It is used solely for exercise purposes.
The TS test system can simulate the following device types:
- Calibration Using ETK
- ES1300 Measurement Card (VADI)
- ODX device (available only with ODX add-on)
Note |
If you want to prepare an experiment, but you do not know which device would be used with the selected project, you can add a virtual system to the workspace for preparing the experiment. The virtual hardware supports rasters and raster checks. |
System parameters
The TS test system itself has no properties for which parameters can be set. Therefore, if you click the corresponding entry under Hardware devices, the right side of the window remains blank.
Working in the Hardware Configuration Editor