ES582.1/ES582.2 Bus Interface Module (USB module for CAN FD)
The ES582.1 and ES582.2 are interface modules for bus analysis on the basis of physical signals as well as for the measurement, calibration and diagnostics of control devices. If you validate the vehicle diagnostics, use the module together with the INCA add-on ODX.
The hardware is connected to the computer at the USB interface.
Before you can use the ES582.1 or ES582.2 in INCA, you must install the USB drivers for the device. They can be found enclosed with the hardware.
Note |
To add an ES582.2 module to your INCA hardware configuration, select the ES582.1 device in the hardware list of the Hardware Configuration Editor, see Adding a Device. |
Module Description
The ES582.1 and the ES582.2 have the following interfaces:
1 independent CAN (FD) interface:
ES582.2 with CAN SIC capability
1 independent LIN interface
INCA supports up to eight ES582.1 or ES 582.2 modules simultaneously.
Module Parameters
Parameters tabNameEnter any name for the system.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Firmware versionShows the firmware version of the connected hardware module.
Applications
Via the CAN interface:
Measurement and Serial Calibration Using CCP
Measurement and Calibration Using UDS (Unified Diagnostic Services)
Model Based Application Using XCPSimTime
Diagnostics Using OBDonCAN (available only with ODX add-on)
Working in the Hardware Configuration Editor