ES581.4 CAN Bus Interface USB Moduel(CAN on USB)
The ES581.4 module is connected to the PC via USB.
It supports the application via the CAN interface of an ECU, as well as the acquisition and recording of communication data on the CAN network.
Note |
Before you can use an ES581.4 module in INCA, you must install the USB drivers for that device. They can be found enclosed with the hardware as well as in the HSP Service Packages. |
System limits
Interfaces:
- Two CAN interfaces
INCA supports up to eight CAN USB modules simultaneously.
Module parameters
Parameters tabNameEnter any name for the system.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Firmware VersionShows the firmware version of the connected hardware module.
Applications
Via the CAN interface:
Measurement and Serial Calibration Using CCP
Measurement and Calibration Using UDS (Unified Diagnostic Services)
Model Based Application Using XCPSimTime
Diagnostics Using OBDonCAN (available only with ODX add-on)
Working in the Hardware Configuration Editor