Showing the Configuration of the PoolRAM

To show the configuration:

  1. Open an experiment.

  2. In the device information bar, click on .

    The Memory Page device window opens. The PoolRAM field is set to unknown.

  1. In the Variable Selection dialog , add any calibration variables from the ETAS_CAL_METHOD group to an INCA editor.

  2. In the INCA editor, enter a new calibration variable value.

  3. In the Variables menu, point to Single Pointered and then select Show configuration.

    In the monitor window, the CALIBRATION_METHOD_SINGLE_POINTERED is displayed with the following configuration:

    PointeredTable

    The number of groups that are emulated.

    PoolRAM fill levelThe number of bytes that have been used by the PoolRAM in Bytes and %.
    GroupnameList of used groups from the variable selection dialog.

Note

The configuration is only shown if the A2L file of the experiment supports the single pointer calibration method and the connected devices are in online mode.

See also

Reconfiguring the PoolRAM Automatically

Opening an Experiment

Select Variables

Variables Menu