Automatically Assigning Sequence Calls

Note
This topic applies only to SWCs specified as block diagrams.

To assign normal sequence calls, do the following:

In the Outline tab, select the process/method to which the sequence calls shall be linked.
Sequence calls can be assigned automatically to one method or process at a time. If you select no, or more than one, method/process, the relevant menu options are deactivated.

Select all elements to which you want to assign sequence calls.

You should only select elements which are to be linked to the same process or method.

Note
If you select no elements, the sequence calls of the entire diagram will be assigned, if possible. Incomplete or incorrect assignments may occur, especially for diagrams with several runnables/methods.

To assign block-local sequence calls, do the following:
1. Open the statement block whose sequence calls you want to assign.
2. Select all elements to which you want to assign block-local sequence calls.
  Note
  If you select no elements, the sequence calls of the entire statement block will be assigned. Incomplete or incorrect assignments may occur.
In the Tools menu, point to Sequence Calls, then point to Sequencing and select Ignore Current.
The selected diagram part is analyzed, and the sequence calls are assigned in accordance with the integrated sequencing algorithm.

Note
If you select no elements, the sequence calls of the entire statement block will be assigned. Incomplete or incorrect assignments may occur.

Note
The sequencing algorithm is subject to several restrictions, see Editing Several Sequence Calls. It is therefore necessary that you proofread the automatic sequence call assignments, and correct them where necessary.