ES720_ES820 Device
The following list shows the module parameters for the ES720_ES820 device:
Module parameters
Enter any name for the system.
Shows the serial number read from the device.
Shows the firmware version of the connected hardware module.
Specifies how the system should react if the connection between INCA and the hardware module is interrupted at measuring start or during measurement.
Abort after failure
The measurement using this hardware module will be terminated in any case of measurement failure (at measuring start or during measurement). The system does not try to reinitialize the hardware module. After the connection has been interrupted, you have to reinitialize manually.
This option is appropriate when, e.g., the measured values are not essential for the experiment, as the module will be ignored after any failure. This option is the default.
Abort at start, try again later
INCA stops measurement of this module in case of failure at measuring start, assuming the module is disconnected or has any systematic problem.
It continues to try measurement in case of failure during the measurement assuming the failure is temporal and can be resolved via retries.
Retry always
INCA continues to try measurement of this module in any case of measurement failure (at measuring start or during measurement).
This option is useful if you want to conduct quick start or cold start measurements.
This specifies whether timestamps are to be rounded or not.
If rounding is enabled, the precision is determined according the following rule:
Divide the acquisition rate by 10 and round to the next smaller power of 10.
Example:
| Acquisition rate | Resolution |
| 10 µs | 1 µs |
| 20 µs | 1 µs |
| 50 µs | 1 µs |
| 0,1 ms | 0,01 ms |
| 0,2 ms | 0,01 ms |
| 0,5 ms | 0,01 ms |
| 1 ms | 0,1 ms |
| 2 ms | 0,1 ms |
| 5 ms | 0,1 ms |
| 10 ms | 1 ms |
| 20 ms | 1 ms |
| 50 ms | 1 ms |
| 100 ms | 10 ms |
| 200 ms | 10 ms |
| 500 ms | 10 ms |
| 1 s | 0,1 s |
| 2 s | 0,1 s |
| 5 s | 0,1 s |
Note |
There are two data types for the timestamp format: |
Shows the channel number.
You cannot edit this field.
Shows the name of the measurement variable.
You cannot edit this field.
Shows the physical unit of the measure variable.
You cannot edit this field.
Shows the lower physical value.
You can not edit this field.
Shows the upper physical value.
You can not edit this field.
Shows the conversion formula used for the hardware module.
You cannot edit this field.
See also
Working in the Hardware Configuration Editor