Rapid Prototyping Interface
The INCA-EIP add-on package allows you to use the INCA measurement and calibration system as an experiment environment for the software development of real-time systems. Using a simulation controller, you get access to the experimental hardware for the E-Target.
Module parameters
Parameters tabNameEnter any name for the system.
Serial numberShows the serial number read from the device.
If the hardware is not connected or if it was not found during the hardware search, enter the complete number by hand (it can be found on the device).
The serial number must be entered as it is needed by INCA to identify the device. The serial number is stored in the hardware configuration.
Alias NameEnter an internal name of the device. It is stored in the device like the serial number and helps you to distinguish between devices of the same type. By assigning a unique name which expresses the role of the device, it can be used more conveniently than the serial number, especially when you link the devices in the Connect Devices dialog box. The alias name is used, for example, if you switch between different vehicles when measuring with the laptop or if you have installed different devices of the same type in the vehicle.
Firmware VersionShows the firmware version of the connected hardware module.
INCA hardware communicationShows the hardware connection between the hardware and the PC.
You cannot edit this field.
See also
Module Parameters for Simulation Controller
Working in the Hardware Configuration Editor