Topology of ES830 Rapid Prototyping System

The ES830 is a rapid prototyping module for the function development with bypass and direct bus access. Using the ES830 Compact Rapid Prototyping device as the E-Target, you can perform in parallel both rapid prototyping of control functions as well as measurements and calibration on the ECU via FETK or XETK.

If you would like to use FETK or XETK access for measurement and calibration, you need to add an FETK or an XETK controller in the INCA Hardware Configuration Editor in addition to the ES830/Simulation Controller.

If you would like to do CAN, CAN FD, LIN or FlexRay monitoring, you have to add an associated bus interface with a monitoring device in the INCA Hardware Configuration Editor in addition to the ES830/Simulation Controller.

System Topology