FETK-S1.0

Defines the type of the microcontroller used in the ECU.

Defines the frequency used for the DAP interface.

Defines whether 1 data pin (DAP1 (2Pin-DAP)) or 2 data pins (DAP2 (3Pin-DAP)) are used. DAP2 supports a higher data rate than DAP1 via the DAP interface.

Selects how the XETK controls the ECU watchdog.

• Controlled by ECU: The XETK will not drive the signal.
• Enabled: Enables watchdog control from the XETK debugger connector. The XETK will drive the signal as configured to enable the watchdog when the debugger requests the watchdog to be enabled.
• Disabled: The XETK will drive the signal as configured to disable the watchdog.

Controls which level of the watchdog disable signal shall disable the watchdog.

• Low: Low level shall disable the watchdog.
• High: High Level shall disable the watchdog.

The ETK has the ability to wake up the ECU by applying voltage to the CalWakeUp pin of the ECU connector. This makes it possible to download the content of the working page and configure a measurement while the ECU is off.

When waking up the ECU via the CalWakeUp pin it can be selected whether the pin is pulled until the microcontroller core voltage (VDDP) is high or whether the pin should be kept on high state until the start-up handshake between ECU and ETK signals to the ETK that the ECU has finished its initialization.

• YES: The CalWakeUp pin will be kept on high state until the start-up handshake between ECU and ETK signals to the ETK that the ECU has finished its initialization.
• NO: The CalWakeUp pin is pulled until the microcontroller core voltage (VDDP) is high.

Selects the signal the ETK will use for ECU standby RAM (working page) power supply supervision.

• ETK Standby Supply: ETK is monitoring the standby supply it provides to the ECU.
• No Standby Supply: ETK is monitoring the standard ECU power supply; the working page is not using a standby supply.

Select the timeout value for the handshake.

• Infinite: This option must be selected for Register Triggering.
• timeout values (1 ms, 10 ms, …): Select one of the timeout values if Timer Triggering is used. ETK will report a simulated successful handshake completion to the software after the selected time has elapsed.

Selects the polling rate in μs. Typically at least twice as fast as the fastest raster in a measurement.

Defines how the XETK shall behave if an overload occurs during data processing.

• Drop Data and Continue Measurement: The XETK drops measurement data, sends an error event and continues measurement.
• Stop Measurement: The XETK stops the measurement and sends an error event.