Module Parameter for SOME/IP MC

Name

Enter any name for the hardware module.

Meas. failure behavior

Specifies how the system should react if the connection between INCA and the hardware module is interrupted at measuring start or during measurement.

• Abort after failure

  The measurement using this hardware module will be terminated in any case of measurement failure (at measuring start or during measurement). The system does not try to reinitialize the hardware module. After the connection has been interrupted, you have to reinitialize manually.

  This option is appropriate when, e.g., the measured values are not essential for the experiment, as the module will be ignored after any failure. This option is the default.

• Abort at start, try again later

  INCA stops measurement of this module in case of failure at measuring start, assuming the module is disconnected or has any systematic problem.

  It continues to try measurement in case of failure during the measurement assuming the failure is temporal and can be resolved via retries.

• Retry always

  INCA continues to try measurement of this module in any case of measurement failure (at measuring start or during measurement).

  This option is useful if you want to conduct quick start or cold start measurements.

Project

Shows the name of the PDU cluster of the AUTOSAR file.

To select a different project: in the Value column, double-click the field next to Project.

SOME/IP Service Discovery Network

Source addresses

Defines the IP address, IPv4 or IPv6, of INCA used for communication.

Subnet mask

Defines the subnet mask. For an IPv4 source address, you have to configure a subnet mask.

Service discorvery port

Determines which service discovery port number is assigned for SOME/IP communication.

Multicast adress

Defines the multicast address. For IPv4, you can configure a multicast address for sending SOME/IP Service Discovery messages.

General Network Parameters

VLAN ID

Defines the VLAN ID for the SOME/IP communication.