Adding Windows

To add measure and calibration instruments in an experiment:

• Click .

  The Variable Selection Dialog opens.

• Select one ore more variables.

• Right-click one of the highlighted variables.

• Select Add to > Layer_n > New > <corresponding instrument>.

  If you have selected measure variables , you can add the following instruments:

  • Measure Window
  • Measure Table
  • YT and XY Oscilloscope Window

  • Sortable List (available only with the INCA-EV-Instruments add-on)

  • Delta Bar Chart(available only with the INCA-EV-Instruments add-on)

  • Signal Distribution Chart(available only with the INCA-EV-Instruments add-on)

  • Absolute Value Bar Chart(available only with the INCA-EV-Instruments add-on)

  • VoiceRecorder (available only with the INCA-VoiceRecorder add-on)

  • INCA-TOUCH (available only with the INCA-TOUCH add-on)

  If you have selected boolean or scalar type calibration variables , you can add the following instruments:

  • Calibration Window
  • Combined Editor
  • Scalar Table Editor Window

  • INCA-TOUCH (available only with the INCA-TOUCH add-on)

  If you have selected vector, matrix, curve, map, or cuboid type calibration variables , you can add the following instruments:

  • Combined Editor

  • Calibration Scenario Editor Interface

  • INCA-TOUCH (available only with the INCA-TOUCH add-on)

• Click OK.

  A new instrument window is added to the experiment.

See also

Activating a Window

Removing a Window

Arranging Symbols