Showing Measure Variables in a Raster

To view all measure variables assigned to the same raster:

Expand the corresponding device in the Sources pane.
Click on Rasters.
All available rasters are shown with their respective filling level in percent and their number of actually assigned and possible number of measure variables. For dynamic XCP rasters, additional detail information, such as CPU utilization and number of ODTs used, is listed.
Expand the Raster subgroup.
The tree structure in the Sources pane opens up and you can see the raster available in the device.
Select the intended raster in the structure.
The measure variables contained in the raster are shown.

Note
Variables can only be shown in rasters which already have a filling level. The raster describes the interval during which a measurement is recorded. Depending on the device the volume of measurements which can be recorded per raster can be limited. This information is deposited in the ASAP2 file.

Note

Variables can only be shown in rasters which already have a filling level.

The raster describes the interval during which a measurement is recorded. Depending on the device the volume of measurements which can be recorded per raster can be limited. This information is deposited in the ASAP2 file.

You can also

Allocating Variables to a Raster