Establish Connection Dialog Box

To open this dialog box, in the Connection menu select Establish Connection.

This dialog box contains the following fields and buttons:

Use IPv6

Activates the use of an IPv6 address. If the checkbox is deactivated, IPv4 is used as standard IP address.

ASAP3

RS232 / V.24 connection ("Serial")

Defines that the connection to the test bench is established via a serial interface.

Port

Defines the serial interface.

Baud rate

Defines the baud rate for the serial connection.

Network connection

Defines that the connection to the test bench is established via a network card or network link.

Network card

Defines the network card via which the connection to the test bench is established.

Local network address

Defines a local network address to establish a connection to the test bench.

Local address

Defines a local address to establish a connection to the test bench.

Local port

Defines the port for ASAP3 connection.

iLinkRT Commands

Network card

Defines the network card via which the connection to the test bench is established.
Useful when no static address available, for example, DHCP.

Local network address

Defines a local network address to establish a connection to the test bench.
Useful for static addresses

Local address

Defines a local address to establish the command connection to the test bench

Local port

Defines the port for iLinkRT command connection.

iLinkRT Get All Server

Version

Select the iLinkRT protocol version number.

Broadcast / Mulitcast address

Defines the IP address to be used for Get All Server and its responses.

Local port

Defines the port for iLinkRT Get All Server connection RT_GET_ALL_SERVER.

iLinkRT Measurement / Events

Use unicast

Defines that unicast sending is used instead of multicast.

Multicast address

Defines the IP address to be used for multi cast (unicast) measurement / event sending.

Local / Multicast port

Defines the UDP port to be used for measurement / event sending.

iLinkRT V3 Watchdog

Interval (sec)

Defines the maximum time allowed between two commands sent by the client. Valid values are between 1 and 1000 seconds. To disable the watchdog, enter 0.

Establish Connection

Establishes the connection and closes the dialog box.

Cancel

Closes the dialog box without establishing the connection.