Operation

Keep the product's operating system and all software up to date with the latest official versions and install security patches immediately. You can find information about updating the firmware in the chapter "Firmware update".

CAUTION 

Only use the equipment as described in this manual. Only use ETAS recommended attachments. Use of non-recommended parts may invalidate the equipment warranty.

DANGER 

Risk of distraction

Use of the ES2504 may distract the driver.

  • Focus on the traffic whilst driving.

  • Do not carry out any actions on the product whilst driving.

WARNING 

Fire Hazard

The ES2504 contains a lithium battery. Damaged lithium batteries may cause heat, fire or short circuits.

If the battery is damaged, shut the product down immediately and contact ETAS Support: www.etas.com/hotlines

Damaged or defective lithium batteries must under no circumstances be shipped by regular parcel service or air freight.

The Material Data Safety Sheet for the battery pack can be found in the product-specific area on the ETAS website: www.etas.com/shipment_dangerous_goods.

CAUTION 

Class 1 laser radiation

This product contains an integrated Class 1 laser scanner (IEC 60825-1:2014) and is safe under reasonably foreseeable conditions of use. To avoid potential hazards, always observe the following safety instructions:

  • Do not look directly into the laser beam or point it at other people. Although this product is classified as Class 1, direct and prolonged viewing of the light beam should be avoided.

  • Do not attempt to open, service, or modify the scanner module. The scanner contains no user-serviceable parts. Opening the scanner housing may expose you to hazardous laser radiation.

  • Use of controls or adjustments or performance of procedures other than those described in these instructions may result in hazardous radiation exposure.

 

Statement of compliance with US FDA requirements:

This product complies with FDA performance standards for laser products except for conformance with IEC 60825-1, Edition 3, as described in “Laser Notice No. 56” dated May 8,. 2019.