Commissioning

WARNING
Risk due to undefined vehicle behavior during an ECU reset If you operate the product in combination with ETKs, the ECU must not be reset in an uncontrolled manner. Only make changes when the vehicle is stationary (e.g. changes to the test setup, changes to the ETK configuration, software updates).

WARNING

Risk due to undefined vehicle behavior during an ECU reset

If you operate the product in combination with ETKs, the ECU must not be reset in an uncontrolled manner.

Only make changes when the vehicle is stationary (e.g. changes to the test setup, changes to the ETK configuration, software updates).

Note
In the INCA hardware configurator, only one active session is supported for the ES166.1 module. If a device is configured for Ethernet monitoring, it cannot be configured simultaneously for other purposes, such as calibration via XCP.

Web interface

The device behaviour (gateway/media converter) and the properties of the device such as the PLCA parameters can be configured via a web interface

Note
When the module is disconnected from the power supply, the last configuration in the web interface is saved and will be available after reboot.

You can determine the IP address of the module with the HSP Update Tool. You can find the tool in the Download Center on the ETAS web page.

Start the HSP Update Tool.
Search for the hardware with <CTRL> + <H>.
In the Hardware window, mark the desired module.
Open the Properties window with <ALT> + <ENTER>.
In the Properties window under Communication > Communication Parameters, you will find the IP address of the module.