Adding and Configuring an IUMPR Table

For more information about this table type, see IUMPR Table.

As a prerequisite, you have imported signals into your configuration. For more information, see Importing Signals. The configuration must also have at least one chapter with one section. For more information, see Adding Chapters with Sections.

To add and configure an IUMPR table

1. Click the + button on section level and select this table type.

2. Click Basic. Make the following settings:

   • Assign a table ID.
   • Optionally, assign a description.

   • To define the display type, select an entry from the drop-down menu.

     If one status for all measurement shall be used, select cumulative. If one status per measurement shall be used, select single. Note that the traffic light on section level is always cumulative.

   • To define the signal type, select an entry from the drop-down menu depending on the kind of DFC signals.

3. Click Save.

4. Click Ratio. Make the following settings:

   • Assign the DFC signals.

     Depending on the selection of either "bit" or "int" as signal type, two or three signals have to be added, respectively. For "bit", add a ratio signal and a bit signal. For "int", add a ratio signal, a nominator signal, and a denominator signal.

   • Assign a group. Input of numbers and / or text is possible.
   • Optionally, you can add a description.
   • To evaluate the signals with respect to traffic light, ratio, and threshold, set the "min" and "low" values.

5. To add more lines and signals for evaluation, click +.

   To delete lines and remove signals, click x.

6. Click Save.