Applying Conditions

Conditions can only be applied to specific display objects. For more information, see Conditions, Triggers, and Filters.

To set a condition, a signal and a reference value / signal must be defined. Optionally, a time delay for the rising edge Edge that is defined by every sample for which the previous sample has a higher value. and the falling edge Edge that is defined by every sample for which the previous sample has a lower value. can be set. If more than one condition is applied, the conditions are joined by the & operator.

To apply conditions

• In the configuration window of the chart, click Conditions.

• To set signals, operators and time delays, do the following:

  • Select an operator from the "Operator" drop-down menu.

  • Type text in the "Signal" field and "Reference value / signal" field, respectively.

    Depending on your text, the imported signals are listed in a drop-down menu.

  • Optionally, adjust the "Delay rising edge" and the "Delay falling edge" by clicking the arrows.
• You can add another condition or delete a condition by clicking + or x.
• When at least two conditions exist, you can choose if the conditions shall be joined either with AND or with OR in the Join column. In the report, this selection is shown in the Chart Properties. For more information, see To get display object information.
• Click Save.