Hardware Options
The Hardware and Hardware Connection nodes contain options required for a successful linking of ASCET models in INTECRIO for integration and rapid prototyping.
Note |
|---|
ASCET‑RP adds further subnodes to the Hardware node. For the meaning of the subnode options, refer to the descriptions in the Options window and to the ASCET‑RP User Guide. |
The Hardware Connection subnode contains the following options:
Check HW connection before Build
Use this option to determine whether, upon starting an experiment (Open Experiment), the hardware search is performed before and after (activated, default) or only after the build process. If no suitable hardware is detected, an error message occurs.
When the option is activated, you can correct the error by adding a suitable hardware without losing the time for the build process.
When the option is deactivated, you can perform the build process without an error message, despite missing hardware.
Skip HW Selection if Exactly one Matching Target Instance found
When this option is activated (default), the Experimental Target Hardware Selection window does not open when only one hardware, which matches the project, is found upon experiment start.
When this option is deactivated, the next option determines whether the Experimental Target Hardware Selection window opens each time you start an experiment. This window offers all experimental targets connected to your PC for selection.
Skip HW Selection if Last Used Target Instance found
When this option is activated (default), the Experimental Target Hardware Selection window does not open when only that hardware which was last used with the project is found upon experiment start.
When this option is deactivated, the previous option determines whether the Experimental Target Hardware Selection window opens each time you start an experiment.
Edit Network Settings
This link opens the ETAS Network Manager.