Highlighting the Net Points in the 3D Editor

1. Do one of the following:

   • Activate the Select Access Point option located above the list.

   • Press the <s> key.

   A cross consisting of four arrows is displayed to the right of the list.

   

   Also, one net point is already highlighted: The point closest to the origin of the 3D coordinate system is highlighted by means of specially colored connecting lines to its neighboring points.

2. Do one of the following to move the highlight up and down or to the left and right:

   • Click the direction arrows.

   • Use the <←>, <↑>, <→>, and <↓> cursor keys.

   The x axis and y axis sample points, together with the corresponding output value, are shown in the Value column of the table. The table also shows the ranges of all three axes.

3. Highlight the net point you want to edit.

4. Enter the new values for X, Y and Z in the Value column.

   Note
   For group and fixed characteristic maps, only the z axis values can be changed.

5. Do one of the following to reset the highlight to its original state:

   • Click the square in the center of the arrows
   • Press the <0> (zero) key.